11
Vax Careline 0870 606 1248
7. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: Cleaner won't run
Cause:
No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause:
Automatic shut-off activated.
Solution: Turn cleaner off and then on again or empty
the dirty water tank (See page 6).
Cause: Filter or filter lid missing or not positioned
correctly.
Solution: Ensure dirty water tank filter and filter lid are
positioned in the dirty water tank lid.
Cause: Dirty water tank or clean water tank not
positioned correctly.
Solution: Ensure both tanks are locked in place.
Cause: Filter is dirty.
Solution: Clean filter.
Cause: Nozzle not properly positioned.
Solution: Ensure nozzle is replaced properly and locked.
PROBLEM: Water puddling behind cleaner.
Cause:
Excess cleaning solution foaming in tanks.
Solution: Use only Vax Floor Cleaner.
Cause: Clean water tank not correctly installed.
Solution: Ensure tank is installed correctly.
Cause: Dirty water tank is full.
Solution: Emp
ty tank.
P
ROBLEM: Cleaner does not pick up dirty solution.
Cause:
Cleaner not set to PICKUP.
Solution: Set mode selector switch to PICKUP.
Cause: Dirty water tank not properly installed.
Solution: Ensure that the dirty water tank is correctly
installed.
Cause: Dirty water tank full / Automatic shut-off
engaged.
Solution: Remove and empty the dirty water tank.
Cause: Filter or filter lid missing or not positioned
correctly.
Solution: Ensure dirty water tank filter and filter lid are
positioned in the dirty water tank lid.
PROBLEM: Cleaner solution won’t dispense.
Cause:
Clean water tank not firmly in place.
Solution: Ensure tank is securely locked in position.
Cause: Clean water tank empty.
Solution: Refill clean water tank.
Cause: Handle not assembled correctly.
Solution: Refer to page 4.
PROBLEM: Brushes won’t rotate.
Cause:
Mode selector switch set to PICKUP.
Solution: Move mode selector switch to SCRUB position.
troubleshooting
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 11
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales